Figured it out. Turn on the computer and depress the F2 key. When the Aptio Setup Utility Screen pops up select Advanced using the arrow keys, then select System Configuration using the arrow keys and hit enter. Select SATA Mode using arrow keys hit enter. Select RAID and hit F10 to save. Say yes to save configuration & reset...BOOM!
That's exactly the solution I used following a replacement of the motherboard. My XPS 8300 has RAID0 in 2 x 1TB which was not detectable by the new board causing "MISSING OPERATING SYSTEM".
Just flippint SATA mode to "RAID" fixed it! KABOOM
And I will get rid of this RAID0 configuration asap. Get an SSD and put the others in RAID1 or without RAID.
bumbledee1
2 Posts
1
July 18th, 2015 20:00
Figured it out. Turn on the computer and depress the F2 key. When the Aptio Setup Utility Screen pops up select Advanced using the arrow keys, then select System Configuration using the arrow keys and hit enter. Select SATA Mode using arrow keys hit enter. Select RAID and hit F10 to save. Say yes to save configuration & reset...BOOM!
Mats66
1 Message
0
September 18th, 2016 11:00
That's exactly the solution I used following a replacement of the motherboard. My XPS 8300 has RAID0 in 2 x 1TB which was not detectable by the new board causing "MISSING OPERATING SYSTEM".
Just flippint SATA mode to "RAID" fixed it! KABOOM
And I will get rid of this RAID0 configuration asap. Get an SSD and put the others in RAID1 or without RAID.