Unsolved
This post is more than 5 years old
4 Posts
0
12275
July 28th, 2006 00:00
loading pbr for descriptor 2...failed
does anybody know how to fix an error that says Loading PBR for descriptor 2...failed
Message Edited by dbflys on 07-27-200608:42 PM
No Events found!
jrwou1
244 Posts
0
July 28th, 2006 01:00
There might be something wrong with your hard-disk.
Follow the steps below:
Start->Run. Type cmd.
In the command-prompt window, type chkdsk /f. Press Enter.
( Note: The scan will take place on next reboot, so you might be prompted for restart.)
dbflys
4 Posts
0
July 28th, 2006 11:00
ejn63
9 Legend
•
87.5K Posts
0
July 28th, 2006 11:00
bertrammoshier
1 Rookie
•
83 Posts
0
August 24th, 2008 07:00
I'm also having this same problem on a Dell Dimension 3000. It normally runs a prime number generation program off in the corner. I shut it down last night and everything was just fine.
Tonight I decided to boot and start the work up again and now I get this error message. One minute it is working, I let the machine sit powered off, and now it won't work. Go figure.
I'm able to get into diagnostics (F10). I have yet to see any errors but they are still running.
If everything looks good where should I go from here?
Thanks!