I received my t3600 yesterday and the twisted black/red wires leading from the PERC H310 were not connected to anything (the card itself was flopping around inside the case, but that's a different story). I assume the wires are for the drive activity light. Where does it connect?
A 2 Pin connector for LED would be for SCSI controller not a PERC RAID.
For that the Disk carriers would have individual activity lights so that you can tell which one is bad.
Thanks for the response. On the PERC card, it is labeled "SAS ACT LED", so I think it is supposed to be the activity light. But in any event, where on the motherboard or in the case does it connect?
There is a connector on the motherboard labeled "AUX_LED" that I am tempted to plug it into, but the t3600 manual says it is the "Front panel audio connector" (connector 14 on page 36 of the owners manual).