Access Controll for iSCSI

Question

Hi All, I have two EqualLogic PS6500E. On the volumes created there, under Access Control List  I have applied and IP address restriction to allow only 192.168.1.* range. From a couple of days under Connections I noticed trafic/connections from other IP addreses (not 192.168.1.* range) that are actually configured on servers accessing this volumes.   Any ideas how is this possible? Thanx in advance Saimo

lottosaimo · Answer

Thanx Don! Excluding all other iSCSI subnets from 'Configure MPIO' was what I did to solve. Latter I will put only the server IP to connect limit the access of the SAN. Regards -- Saimo

EqualLogic

Was this post helpful?