Yes creating a new vSwitch is good choice.
You are only going to need 2x 10GbE NICs. More than that won't provide better performance and takes memory away from the arrays.
Qlogic bought Broadcom so you fine there.
Social Media and Community Professional
Get Support on Twitter - @dellcarespro
Ok so here is where i'm at at the moment:
a two port 10gbe nic has been installed to my three existing hosts
A 10gb switch has been installed and configured
the two new san's are installed and configured.
I'm am currently at the vmware configuration. I am unsure about what i should do about vswitches and vmkernels.
I was about to create a new vswitch and assign the host's two new 10gbe ports and create a vmkernel for isci. Would that be it?
I guess i need to set up a new switch for vmotion or will it go through my existing vswitch for vmotion that uses my 1gb network?
Any pointers would be greatly appreciated, i'm so close to being done
You are going to want to set up a vSwitch w/two 10GbE NICs/VMkernel ports for ISCSI.
They will have to be bound to the iSCSI software adapter.
This is a PDF on setting up best practices
This is how to set up iSCSI with VMware and EQL
Ok so i followed the procedure, since i already had a iscsi software adapter i edited it to add the two new ports on the host in the network port binding section. In the Target tab i added the ip of my new equallogic group.
I then tried to rescan everything. I'm not sure that it works though. Kinda stuck there at the moment.
Did you create a volume on the Group and allow it access to your servers?
In the setup PDF I believe there is a section that discusses how to do that.
Do you have a support contract for these arrays?