Unsolved
This post is more than 5 years old
1 Message
0
2084
iSeries STM failover done with wrong option how to resync?
We have 2 iSeries with an iASP replicationg using SRDF.
on V7.2.0
STM 8.3.0.4 and SYMAPI V8.3.0.0-2252.
A IASPFAILOV was done with option *NO instead of Establish.
So now on the SRDF is in FAILED OVER status.
As this is a production system with very few outages we would like to get this in Synchonized mode again.
On the system with the ASP active
Node1
CTLACT IMAGE_NAME(IASP144) PATH_NAME(SRDF) STEPNUM(1) ACTION(STATUS)
shows
The SRDF status is Failed Over for the devices in the IASP144 image, SRDF path, step number 1.
The SRDF type for devices in this step is R2. The SRDF mode for the step is Synchronous.
IASPCTL IMAGENAME(IASP144) PATHNAME(SRDF) STEPNUM(1) ACTION(STATUS) NODENAME(NODE1)
shows
Link status - Failed Over , Invalid Tracks - 0 , SRDF Type Source Devs - R2, IOA Status - IOA's active, IASP Status - Available.
Node2
CTLATTGT IMAGE_NAME(IASP144) PATH_NAME(SRDF) STEPNUM(1) ACTION(STATUS)
shows
The SRDF status is Failed Over for the devices in the IASP144 image, SRDF path, step number 1.
The SRDF type for devices in this step is R1. The SRDF mode for the step is Synchronous.
IASCTLC IMAGENAME(IASP144) PATHNAME(SRDF) STEPNUM(1) ACTIION(STATUS) NODENAME(NODE2)
shows
Link status - Failed Over , Invalid Tracks - 0 , SRDF Type Source Devs - R2, IOA Status - IOA's active, IASP Status - Varied Off.
On our development system it was done correctly and shows as
Node1D
CTLACT IMAGE_NAME(IASP144D) PATH_NAME(SRDF) STEPNUM(1) ACTION(STATUS)
shows
The SRDF status is Synchronized for the devices in the IASP144D image, SRDF path, step number 1.
The SRDF type for devices in this step is R1. The SRDF mode for the step is Synchronous.
IASPCTL IMAGENAME(IASP144D) PATHNAME(SRDF) STEPNUM(1) ACTION(STATUS) NODENAME(NODE1D)
shows
Link status - Synchronized , Invalid Tracks - 0 , SRDF Type Source Devs - R1, IOA Status - IOA's active, IASP Status - Available
NODE2D
CTLACTTGT IMAGE_NAME(IASP144D) PATHE_NAME(SRDF) STEPNUM(1) ACTION(STATUS) NODENAME(NODE2D)
shows
The SRDF status is Synchronized for the devices in the IASP144D image, SRDF path, step number 1.
The SRDF type for the devices in this step is R2. The SRDF mode for the step is Synchronous.
IASPCTLC IMAGENAME(IASP144D) PATHNAME(SRDF) STEPNUM(1) ACTION(STATUS) NODENAME(NODE2D)
shows
Link status - Synchronized , Invalid Tracks - 0 , SRDF Type Source Devs - R1, IOA Status - IOA's not active, IASP Status - Varied Off.