Unsolved
This post is more than 5 years old
1 Message
0
55565
December 8th, 2011 07:00
U2412M, input timing is not supported, #1
Hello!
i just bought a new u2412m and i am having it connected together with an old dell 2001fp to an dell dimension 9200. When i am setting the u2412 as primary monitor i get the error:
"The current input timing is not supported by the monitor display. Please change your input timing to 1920x1200 @60hz or any other monitor listed timing as per the monitor specifications."
Before that the monitor sometimes i only can see the upper half of the screen. i checked the settings and they are 1920x1200 and 60hz.. i would really appreciate any help! thanks in advance.
best,
thomas untersweg
No Events found!
DELL-Chris M
Community Manager
•
56.9K Posts
•
232.1K Points
0
December 9th, 2011 18:00
For now, remove the dual monitor setup. Disconnect the 2001FP and try to setup the U2412M as the only monitor.
tony_cincinnati
2 Posts
0
February 5th, 2012 11:00
I just installed my new U2412M this morning and have the same error message with blue speckles on screen. I am replace the original dell 24" which worked fine other than screen burn-in. I am not using dual monitors and connected through the DVI connection.
sheldonnesdale
2 Posts
0
February 20th, 2012 13:00
Similar story for me. I have dual U2412M monitors connected via a 10m DVI cable and a 5m DVI cable on "Extend display" mode.
One of my monitors shows that error, but when I change the display to 60Hz it changes it back to 59Hz.
Very annoying.
Is this a graphics card problem, a DVI cable problem, or a monitor problem?
tony_cincinnati
2 Posts
0
February 20th, 2012 14:00
All my problems disappeared without doing anything?????
JieZhang
6 Posts
0
June 28th, 2012 22:00
Seems this problem is very annoying...i have the same problem
Hyenas
25 Posts
1
September 20th, 2012 13:00
I have exactly the same issue. As near as I can tell, this $400 monitor only does 60 Hz even at 640x480. That's mind blowingly awful and literally gives me headaches.