Unsolved
This post is more than 5 years old
2 Posts
0
2313
November 10th, 2011 03:00
Command line interface to EMC NetWorker
I've found a EMC Legato Commands reference (http://www.ipnom.com/Legato-NetWorker-Commands/). How is this command line api accessible from a Windows Server deployment of EMC NetWorker 7.x
No Events found!
masonb
445 Posts
0
November 10th, 2011 04:00
Irfanhabib,
I am not sure I understand your question here? The command line reference gives you the syntax to run commands from the command prompt on Windows for tasks you can perform via NMC, so for instance to load a volume into a tape drive you can select volume and drive in GUI then right click and select mount or from a command window type: -
nsrjb -s
Both accomplish loading a tape into a drive.
Regards,
Bill Mason