Email sending issue using blat with networker 19.3.0.4

Question

Hello, we always use blat.exe to send email notification that we configure at action level in NMC. this works for v19.1.1.1. we upgraded to v19.3.0.4 and we found out that it doesn't work ( FYI the same command when run from CMD of the backup server, it works but from NMC it does not work) it works for v19.4.0.4 it does not with v19.4.0.1  is anyone facing the same problem?

crazyrov · Accepted Answer

@hend_bs, just a hunch but can you try and provide the complete path to the blat.exe and see if that works?

bingo.1 · Answer

Unfortunately, I cannot help you with your problem. But why don't you just rely on NW's own command - smtpmail? E:
sr\bin>smtpmail -?Usage: smtpmail [-s subject] [-h smtphost] [-p port] [-f sender] recipient [recipient[...]]E:
sr\bin>

hend_bs · Answer

Hi Bingo, it is because smtpmail.exe does not support authentication.

hend_bs · Answer

HI Crazyrov, Yes that's the solution ! thank you :))

NetWorker

Was this post helpful?