No Import/Export ports available - ADIC Faststor2

Question

I am trying to configure Legato Networker 7.3 and an ADIC FastStor2 Library consisting of 1 HP-LTO3 tape drive and 8 slots. The library and drive are configured and I can backup and restore without any issues. My problem is that when I try to use Legato to Withdrawl or Deposit tapes from within Legato Networker I get the following error: Jukebox `adic_fs2' indicated that there are no Import/Export ports available; Hardware is HP DL380 SCSI Adapter is Adaptec 3960 ultra160. Has anyone been successful at getting this to work with an ADIC FASTSTOR2 Library and any version of Networker. BTW I can import export manually from the unit front panel and I can also import export using the ADIC GUI. Any input would be useful.

ble1 · Accepted Answer

What do you get when you run something like nsrjb -Vv

Also, see in GUI what is the SCSI address of the library and then feed that address against sjirjc command. Here is one example:

[root@hcrvelin]/#sjirjc 2.8.2
 
                Device: 2.8.2
 
                   Number of Drives: 2
                 Number Drive Pairs: 1
   Number of Import/Export Elements: 0
      Number of Import/Export Pairs: 1
                    Number of Slots: 15
               Number of Slot Pairs: 1
       Number of Transport Elements: 1
          Number of Transport Pairs: 1
 
      Volume Tags Supported
Initialize Element Status Supported
        Bar Codes Supported

Another approach would be to run sjirdtag _your_SCSI_address_, but above should be enough for start.

ble1 · Answer

Btw, usually such small autoloaders do not have I/O cap so I would assume this is your case.

ble1 · Answer

Btw, usually such small autoloaders do not have I/Ocap so I would assume this is your case. According to specs this library does not have I/O ports. FastStor 22 does, but FastStor 2 does not.

gsterle1 · Answer

C:\Documents and Settings\Administrator>nsrjb -Vv
setting verbosity level to `1'
Configuration information for jukebox adic_fs2:
model: Standard SCSI Jukebox
control port: scsidev@3.5.1
bar code reader: Yes
jukebox features: volume_tags elements_status read_elem_unload_fail barcode
number drives: 1
devices: \\.\Tape0
physical slots: 1-8
cleaning slots: 8-8
available slots: 1-7

ble1 · Answer

Here is my result I think you confirmed what I didnot what to hear.I'm afraid so as it says following:Number of Import/Export Elements: 0

gsterle1 · Answer

:\Documents and Settings\Administrator>sjirjc 3.5.1

Device: 3.5.1

Number of Drives: 1
Number Drive Pairs: 1
Number of Import/Export Elements: 0
Number of Import/Export Pairs: 1
Number of Slots: 8
Number of Slot Pairs: 1
Number of Transport Elements: 1
Number of Transport Pairs: 1

Volume Tags Supported
Initialize Element Status Supported
Bar Codes Supported

Here is my result I think you confirmed what I did not what to hear.

NetWorker

Was this post helpful?