Unsolved
This post is more than 5 years old
40 Posts
1
3053
On the fly Encryption in Networker
Does Networker support on the fly encryption for the data being backed up, I guess it only encrypts the data when it reaches the tape drive / any device with AES 256 bit encryption, please correct me if I am wrong.....
ble1
2 Intern
2 Intern
•
14.3K Posts
1
January 27th, 2015 07:00
I believe NSR does it on client, but normally if you really needed you would use HW module which encrypts data on target.
Diego.Palopoli
1 Rookie
1 Rookie
•
32 Posts
0
May 9th, 2017 23:00
You are not wrong ShubhamMishra, Networker save command is in charge of encrypting the backup data when a scheduled client backup job runs, which means, the encryption happens on client side.
Same happens when a recovering activity take place; encrypted backup data goes from Storage Node to client and then (and there) decrypted.
AES encryption directive works similar to others directives (exclusion, compression, etc); it change the way save command will do the backup and send the data to Storage Node.
ShubhamMishra
40 Posts
1
May 10th, 2017 00:00
Thanks for reply, do we have a written evidence that we do encrypted restore....
wlee
263 Posts
1
May 10th, 2017 07:00
NetWorker supports AES encryption. This is documented in the NetWorker Administration Guide, as well as in the following knowledgebase article:
How to encrypt data in NetWorker
https://support.emc.com/kb/322909
Diego.Palopoli
1 Rookie
1 Rookie
•
32 Posts
0
May 14th, 2017 23:00
ShubhamMishra, Wallace shared first the resources (guide and KB); is it clear enough there?