This post is more than 5 years old
2 Intern
•
253 Posts
1
3414
December 1st, 2015 05:00
Tape not loading during recover
I was running a DR test on a remote site and when I ran the recover command it would not load the tape.
Am I correct in assuming that it is supposed to load the tape or is it something I need to do manually?
It knew where the tape was and even said it was near-line but never loaded it.
The jukebox worked fine for inventory and everything else but not recover
Any help is appreciated
0 events found
No Events found!
lalexis
2 Intern
•
253 Posts
0
December 2nd, 2015 08:00
I stand corrected, it does see the jukebox from the command line it appears that the NMC cannot though
bingo.1
2.4K Posts
0
December 2nd, 2015 08:00
The most obvious: You have not been added as a remote user with the appropriate rights.
ble1
6 Operator
•
14.4K Posts
•
56.2K Points
0
December 2nd, 2015 10:00
This error (auth error) suggests issue with nsrauth key not valid or using older NMC with newer NSR with different auth models.
MoinMansuri
2 Intern
•
147 Posts
0
December 4th, 2015 02:00
Hi,
You should check remote host entry and check if you have defined recover storage node properly.
Moin