Browse Community
Help
Log In
Responses(2)
Solutions(1)
bingo.1
2.4K Posts
0
August 5th, 2016 05:00
This is not a bug - it is "good old NetWorker".
You should have looked at mminfo's 'sumflags' attribute and you should have seen that. For example:
... ssid fl
12345 cb complete & browsable
23456 hb header & browsable
23456 mb middle & browsable
23456 tb tail & browsable
Be aware that there could be more than one 'middle' part.
So how to check for the correct sequence? - use mminfo again like in this example:
swadm
44 Posts
August 5th, 2016 06:00
Thanks a lot for that tip!
I looked at so many columns of mminfo, but did not realize that sumflags would have answered the question about the saveset completeness.
Thanks and regards, Tom
Dell Support Resources
View All
Top
bingo.1
2.4K Posts
0
August 5th, 2016 05:00
This is not a bug - it is "good old NetWorker".
You should have looked at mminfo's 'sumflags' attribute and you should have seen that. For example:
... ssid fl
12345 cb complete & browsable
23456 hb header & browsable
23456 mb middle & browsable
23456 tb tail & browsable
Be aware that there could be more than one 'middle' part.
So how to check for the correct sequence? - use mminfo again like in this example:
swadm
44 Posts
0
August 5th, 2016 06:00
Thanks a lot for that tip!
I looked at so many columns of mminfo, but did not realize that sumflags would have answered the question about the saveset completeness.
Thanks and regards, Tom