Not sure if you can get an alert for any change done on any of the resource, but yes you can collate a report which can tell you what all changes have happened using DPA which will give you a report in easy to read format. Else you will have to define a script which tracks user initiated changes happening on that file and shoot an email.
Panwar
79 Posts
1
October 10th, 2012 00:00
Hi,
Please refer the below KB article link. It will guide you to enable the rap.log on the NetWorker server
http://solutions.emc.com/EMCSolutionView.asp?id=esg107154&usertype=C
Regards
Panwar
ble1
4 Operator
•
14.4K Posts
2
October 9th, 2012 13:00
rap.log (enabled as RAP logging in server properties)
ShubhamMishra
40 Posts
0
September 5th, 2016 06:00
Hi All,
I have configured the same, can i get notifications of the same in my email.
for e.g: if someone changes the NMC administration password, I should get an email alert for the same... is that possible...
Thanks
ShubhamMishra
40 Posts
0
September 5th, 2016 06:00
Hi All,
I have configured the same, can i get notifications of the same in my email.
for e.g: if someone changes the NMC administration password, I should get an email alert for the same... is that possible...
Thanks
SurajPujari
155 Posts
0
October 4th, 2016 12:00
Hi Shubham,
Not sure if you can get an alert for any change done on any of the resource, but yes you can collate a report which can tell you what all changes have happened using DPA which will give you a report in easy to read format. Else you will have to define a script which tracks user initiated changes happening on that file and shoot an email.
mkeil
68 Posts
0
October 4th, 2016 23:00
Hi,
you can also try gstclreport to run NMC reports (User Audit) and handle the notification in a script.
mkeil