using jbedit

Question

Hi,

In my setup, I have shared my s24 library and map it to the other storage nodes. I had configure it through jbconfig. I just want to add one more server to that and I used jbedit command . but it gives some error for that which is as below-

C:\>jbedit -a -f INDELHMEYIN22.mea.ey.net:\\.\Tape0 -E 256 -v -s indelhmeysql04.
mea.ey.net -j adic@3.2.1
setting verbosity level to `1'
jbedit: Changing device name from INDELHMEYIN22.mea.ey.net:\\.\Tape0 to rd=INDELHMEYIN22.mea.ey.net:\\.\Tape0.
jbedit: RAP error: Could not find any storage nodes in the RAP database!

Pls. help me out..

ble1 · Answer

From what host are you running jbedit. Do you have permissions for that user at that host?

pnagpal · Answer

I have run the command from Networker server i.e. indelhmeysql04 and the new server on which i want to map library is indelhmeyin24.

pnagpal · Answer

Now I am getting the following error with the other server -

C:\>jbedit -a -f INDELHMEYIN24.mea.ey.net -E 256 -v -s 10.212.20.43 -j adic@3.2.
1
setting verbosity level to `1'
jbedit: RAP error: Cannot find device `INDELHMEYIN24.mea.ey.net' in 'unconfig de
vice names' resource.

ble1 · Answer

What is INDELHMEYIN24.mea.ey.net? Why IP for server?

pnagpal · Answer

Indelhmeyin24 and INDELHMEYIN22 are the two server which I want to attached with the library . and the IP address is of my networker server that I tried by name and by IP to attached the servers by it.

ble1 · Answer

-f should be device name, eg: jbedit -s server -j jbname -a -f sn:/dev/rmt/0cbn -E 256

pnagpal · Answer

Hi,I am using windows 2003 clients.so what would be the command for that-networker server - indelhmeysql04client servers - indelhmeyin22 and indelhmeyin24

ble1 · Answer

Command is always the same - it is only device path that is different. And if you use DDS I think you need -i too then - check manual.

xvan_egmond · Answer

When using NW73+ jbedit checks the new resource NSR storage node. If the drive to be configured is not there as an unconfigured device it will not work.
Please go to devices-storage nodes, there right-click on the newly created storagenode and select scan for devices.
In the logging page you shoud now see the new tape unit appear.

Please use
jbedit -af -E -j jukebox
to add the new drive.

NetWorker

using jbedit

Was this post helpful?