Authentication error while adding a Cisco switch in Openmanage Network Manager

Question

I am trying to get a Cisco Switch in the Dell Openmanage network manager. I am able to telnet the switch, and login is also no problem. I set up the authencation the same way as putty: ip, telnet poort 23, and username en password.  But always the same problem..... Authentication error. What's going wrong ? Discovering network: 10.101.0.80-255.255.248.0   Discovering Class C Network: 10.101.0.0, 1 devices... Pinging Devices... Responsive devices... Resolving Device Hostnames...     Resolved Device Hostnames.. Unresolved Device Hostnames...    Validating Device Authentication...   1 Did not Respond to Authentication. Please click here for the list of devices that did not respond. Will attempt to manage these as default devices.    No new Devices were detected with selected Discovery Parameters

vt1012 · Answer

OMNM is licensed for Dell devices only. To manage both Dell and non-Dell devices, it is recommended to use Redcell which can be purchased through any Dell sales representative.

See the bottom of the page at www.dell.com/networkmanager

Barrett

Networking General

Was this post helpful?