Unsolved
This post is more than 5 years old
1 Message
0
30949
January 13th, 2015 14:00
Dell N3048 configuration
New to Dell switching. In Cisco port configuration I could do a "no" command to remove settings on a port. What is Dells command to remove settings from a port?
No Events found!
DELL-Josh Cr
Moderator
•
9.6K Posts
•
42.5K Points
0
January 13th, 2015 16:00
We use the no command as well. ftp.dell.com/.../networking-n3000-series_Deployment%20Guide4_en-us.pdf
Duncan_A_H
16 Posts
0
February 12th, 2015 06:00
Hi...I have 3 Dell N3024 switches and I am trying to configure vLan routing on them. It sort of works, but I am not sure if I have done it correctly. Each switch has 4 vLans, and there are 12 in total. I have defined all the vLans on each switch, but only assigned IPs to the vLans at the site the switch will sit at (currently, they are all on a build bench and trunked directly together).
Is that right, or should each vLan have an IP on every switch required to participate in routing?
Any help much appreciated.
Thank you