Dell Networking N3024 and Dell Networking N2024P Trunking using GUI.

Question

I am new here for using dell. I have Mikrotik CCR1036 Connected to Internet, I have a Dell Networking 3024, Then I have 5 Dell Networking N2024P deploying In each floors. I also have 20 Dell Networking X1026P for each Departments in a building. I have 2 network cable go to each floors. Here is My Network Structure Internet --> Mikrotik CCR1036 --> VLAN Trunk Dell Networking N3024 --> VLAN Trunk Dell Networking N2024P -->VLAN Access Dell Networking X1026P --> All PC MY Question are: Can you guide me with GUI Configuration 1- Can I use VLAN Trunk between Mikrotik and Dell Networking N3024? 2- How to trunk Dell Networking N3024 with Dell Networking 2024P with my 2 network cables? 3- Can I use 2 cables as failover using LAG? AND how to use LAG with VLAN Trunk? 4- Can you recommend me of best practices of using all my network devices above if It is bad?

nimsambath · Answer

There must be 20 VLAN in the building, VLAN1 to VLAN20. VLAN1 - 192.168.1.1 VLAN2 - 192.168.2.1 VLAN3 - 192.168.3.1 || || VLAN20 - 192.168.20.1

nimsambath · Answer

Where are Dell support? I posted it for 2 days, But still not get any help from Dell, It is very bad support, For Ubiquiti, I can ask questions anytime. I read User Guide many time about VLAN and I try many time, It didn't work, So I decide to post here for any help.

Can anyone help me, How to use VLAN Trunk with LAG?

Networking General

Was this post helpful?