Dell S4148F-ON vlan tagging

Question

Hello, I'm new to Dell switches and we received a Dell S4148F-ON model. I've been trying to look up everything I can about the initial configuration and I'm getting stuck trying to assign the ports to the VLAN's I've created. In the different manuals and how to's I've seen they always end in accessing the VLAN interface and using a untagged or tagged command. My problem is that those commands are not available all I see is: Blah-blah(conf-if-vl-104)#description Provide a textual description of the vlan interfaceend Exit to the exec Modeexit Exit from current modeip Interface Internet Protocol config commandsipv6 Set the IPV6 address of an interfacemtu Configure interface link MTUno Negate a command or set its defaultsremote-span Configure this vlan as RSPAN vlanshow show configurationshutdown Shutdown the vlan interfacevrrp VRRP mode configurationvrrp-group Configure a VRRP IPv4 groupvrrp-ipv6-group Configure a VRRP IPv6 group Can anyone tell me what I'm doing wrong and how the heck I assign a vlan to an ethernet interface on this thing?

DELL-Josh Cr · Answer

Hi,

If you have the VLAN created you should be able to go to the physical interface or port channel and use interface vlan. Page 110 https://topics-cdn.dell.com/pdf/force10-s4048-on_reference-guide7_en-us.pdf

Networking General

Was this post helpful?