InterVLAN Routing over a layer three switch?

Question

Hi, We have a Dell N4032F switch, and we'd like to route between the 10.10.0.x network, and the 10.10.1.x network. I believe, as it's a layer three switch, we wouldn't therefore have to configure any routing on an actual router. I also believe the following configuration should suffice conf t ip routing int vlan 100 ip add 10.10.0.254 255.255.255.0 exit int vlan 200 ip add 10.10.1.254 255.255.255.0 exit copy run start   We'd basically then want 10.10.0.13 could talk to 10.10.1.50 (and vice versa), or anything in either range I don't think you'd need to add in the following routes, which may in itself cause a routing loop?   ip route 10.10.0.0 255.255.255.0 10.10.1.0 ip route 10.10.1.0 255.255.255.0 10.10.0.0   Please advise. Thanks

DELL-Josh Cr · Answer

Hi, Yeah that looks fine. Are both VLANs directly connected to the switch?

wahmed_bw · Answer

@DELL-Josh Cr wrote: Hi, Yeah that looks fine. Are both VLANs directly connected to the switch? Hi Josh, Yup. Both are connected directly to the switch

Networking General

Was this post helpful?