Unsolved
This post is more than 5 years old
7 Posts
0
1864
November 28th, 2016 20:00
InterVLan Routing
I currently have 7 layer 3 switches. I have 2-n4032 switches for my backbone. I have 2-Dell n3024p switches in one closet. A HP Procurve in the server room and 2-Dell n3024 switches in the server room. The HP Procurve has ip routing enabled with 5 vlans. It is the orginal switch. I have added the n4032 switches which are also tied to the iscsi. I am wondering if I should configure each switch with ip routing and a ip address for each vlan on each of the switches. Or do I let the Procurvedo all the routing and setup the other switches as layer 2.
0 events found
No Events found!
LantechSolution
7 Posts
0
November 30th, 2016 13:00
Thanks for your reply. The issue i have now is that the HP Procurve was the first switch installed. I was the core switch until we purchased the Dell switches. I am planning to make the n4032 my core switch sometime soon but I need to get the new switches talking.
What is the commands can I use to remove routing on the vlans and remove things period?
LantechSolution
7 Posts
0
November 30th, 2016 14:00
I found the routing commands.
LantechSolution
7 Posts
0
November 30th, 2016 15:00
I have another question and please excuse me as I am new to the cli. How can I remove the following from a port?
interface Te1/0/11
switchport mode trunk
switchport access vlan 10 <- I need this removed
switchport trunk allowed vlan 10-11