This post is more than 5 years old
1 Rookie
•
38 Posts
0
1245
May 18th, 2020 02:00
Management port on operations network
Hi,
Apologies in advance, to me this looks like a basic question but I don't seem to find an answer.
Conceptually, I understand that a management port on a switch is normally intended to be connected to a management network (e.g. 10.1.0.0/24) separated from the network operated by the switch (e.g. 10.2.0.0/24). However, I would like the management port on my switch to be reachable on the same subnet that the switch is operating on. How can I best achieve this?
Many thanks.
0 events found
No Events found!
DELL-Josh Cr
Moderator
•
9.6K Posts
•
42.2K Points
0
May 19th, 2020 09:00
Page 42 https://dell.to/2WM5Auk it seems like it should work.
DELL-Josh Cr
Moderator
•
9.6K Posts
•
42.2K Points
0
May 18th, 2020 10:00
Which model switch? Some of ours won’t allow this and some will.
slunav
1 Rookie
•
38 Posts
0
May 19th, 2020 07:00
Hi,
I am trying to do this on a S3048, is it possible?
Many thanks.
DELL-Josh Cr
Moderator
•
9.6K Posts
•
42.2K Points
0
May 19th, 2020 12:00
Right.
slunav
1 Rookie
•
38 Posts
0
May 19th, 2020 12:00
Hi,
So following up with my previous example, say my operations network is 10.2.0.0/24. Then I configure the management port with address 10.2.0.100 following the instructions on page 42. The next step would be to connect the management port into one of the operations port (i.e. from 1 to 48) with an ethernet cable?
Many thanks.
slunav
1 Rookie
•
38 Posts
0
May 24th, 2020 00:00
Many thanks!