Multiple address in Vlan 1

Question

Hi I am in the process of upgrading an active powerconnect 5324 switch to a EMC 2000 series switch.   In the startup-config of the old switch I am noticing 2 ip addresses: interface vlan 1ip address 10.136.###.### 255.###.###.###ip address 192.168.0.### 255.255.255.###exitip default-gateway 10.136.###.### While on the new switch it seems like I can only enter 1 ip address in Vlan 1 Is there a way to get the Vlan 1 on the new switch to take 2 Ip addresses? Thanks

DELL-Josh Cr · Answer

Hi,

You should be able to use the command ip address to do it

ip address ip-address { {subnet-mask | prefix-length} [secondary]|dhcp|none}

specify secondary when you set it. Page 2084 https://dell.to/3oBg1yq

Networking General

Was this post helpful?