I just upgraded some N2048 switches and 6.5.4.4 works fine. I have updated boot codes (U-Boot 2012.10-00079-g20827d2 (May 22 2017 - 16:58:14)) and CPLD (20) on the switches when upgrading to 6.5.4.4.
When I upgraded 6.6.0.2 on one switch everything seemed to be ok when checked after upgrade from console. When I connected my laptop to a port, dhcp worked but nothing else. No management connection after upgrade.
When I checked the mac address table from console, there was only switch, no mac from laptop, no macs from uplink port (should have been hundreds of them). Configuration is very basic L2, 5 vlans, ssh+snmp for management, management access-list, 1 trunk port.
When I rebooted the switch to version 6.5.4.4 it works fine.
DELL-Josh Cr
Moderator
•
9.5K Posts
0
July 19th, 2019 14:00
Hi,
Both are stable releases, it is just the two most recent that we have on the page.
erkkiv
1 Message
0
September 11th, 2019 05:00
Hi,
at least version 6.5.4.4 is stable.
I just upgraded some N2048 switches and 6.5.4.4 works fine. I have updated boot codes (U-Boot 2012.10-00079-g20827d2 (May 22 2017 - 16:58:14)) and CPLD (20) on the switches when upgrading to 6.5.4.4.
When I upgraded 6.6.0.2 on one switch everything seemed to be ok when checked after upgrade from console. When I connected my laptop to a port, dhcp worked but nothing else. No management connection after upgrade.
When I checked the mac address table from console, there was only switch, no mac from laptop, no macs from uplink port (should have been hundreds of them). Configuration is very basic L2, 5 vlans, ssh+snmp for management, management access-list, 1 trunk port.
When I rebooted the switch to version 6.5.4.4 it works fine.
regards
Erkki Vänskä
University of Eastern Finland