N2048P Stack use MLAG to Router?

Question

N2048I have 2 - N2048P switches configured as a stack and I want to use one port on each switch to LAG connection to Router to increase our speed and consolidate internal traffic to one logical port-channel. Would I still need a connection between each switch for the peer link since they are stacked? Image below would just change the bottom switch to router. Thanks for your help.

Is this possible to do on N2048 stacked switches?

DELL-Josh Cr · Answer

Hi Duke,

You do not need a peer link between the switches, that is only if you are using VLT. Stacking takes care of that part in your case and you can just create a port channel with a port from each of the stacked switches.

Networking General

N2048P Stack use MLAG to Router?

Was this post helpful?