PowerConnect 6024 VLAN Routing Configuration

Question

I have a PowerConnect 6024 and Cisco ASA 5510 at the moment.  I am trying to setup a few VLANs on the 6024 that will route between each other and outside of VLAN goes to the Cisco Firewall.  Currently, I can do interVLAN communications but do not know how to insert the configurations for routing between the Dell switch and the Cisco Firewall. I've setup the switch to VLAN 2  /192.168.20.1  (trunked LAG port 3,4)    =>  to linksys SRW2024 #1 (multipel VLAN configured) VLAN 3 / 192.168.30.1  (trunked LAG port 5,6)    =>  to linksys SRW2024 #2 (multipel VLAN configured) VLAN 4 / 192.168.40.1  (trunked LAG port 7,8)    =>  to linksys SRW2024 #3 (multipel VLAN configured) Cisco's Inside Interface 192.168.20.250, Outside Interface 194.10.10.10 (fake number) Current, interVLAN on any of the Linksys works but how do I setup to route to the Internet ? I have seen that I need to use 'Route IP  x.x.x.x x.x.x.x y.y.y.y' but have no clue as to how or what.

J. Tsai · Answer

I've seen the article but do not know how it applies,

For example, how does "ip route 10.10.0.0 255.255.255.0 10.10.0.2" applies to my situation ?

ip route 192.168.10.0 255.255.255.0 192.168.10.2 (what is 192.168.10.2 ?)

What would be the static route look like in my environment ? is the 172.16.0.0 a VLAN and the 131.16.1.1 the inside interface on the Firewall ?

J. Tsai · Answer

Another issues is where to plug in the firewall uplink ?  I have a 254 VLAN trunked to another switch.   Should I use like port 1 on the Dell to uplink to the Firewall and configure port 1 to be part of untagged 254 VLAN ?

J. Tsai · Answer

I thought the above route command didn't work but the issues was the routes wasn't defined in the ASA !

Networking General

Was this post helpful?