PowerConnect M8024 and OpenManage Essentials 1.2.1

Question

Hi,

We have installed OpenMange Essentials to manage our Dell hardware (PowerEdge servers, M1000e chassis' and PowerConnect switches.

We have configured SNMP inventory and discovery for M6220 and M8024 switches, but M8024 ones don't show their service tag (other inventory items are ok). M6220 inventory is complete.

SNMP community used for discovery is a read only community.

Where is the mistake?

Thanks in advance for your suggestions

Moreno

DELL-Josh Cr · Accepted Answer

Update the firmware to the latest version, this issue was resolved in 5.1.1.7

http://www.dell.com/support/home/us/en/19/Drivers/DriversDetails?driverId=TGMT6&fileId=3340679749&osCode=NAA&productCode=powerconnect-8024&languageCode=EN&categoryId=NI

DELL-Josh Cr · Answer

Hi Moreno, Does the switch show the service tag when you run show system id? What version is the switch firmware?

Granarolo · Answer

Hi Josh, I will schedule the updates. Thank you Moreno

Granarolo · Answer

Hi, You're right, service tag field in 'show system id' is set to 'none', how can i fill it in? Firmware version is 5.0.1.3 Moreno

Networking General

PowerConnect M8024 and OpenManage Essentials 1.2.1

Was this post helpful?