Hi,

run the command

show switch

and it should list out all of the stack members and we can see if any are missing.

Hi Josh,

When I ran "show switch" command I got below result:

console# show switch
Unit  MAC Address        Software    Master    Uplink     Downlink   Status
----  -----------------                 ----------  --------  ---------  ---------  -------
1     xx:xx:xx:xx:xx:xx            4.1.0.8     Enabled   2          5          master
2     xx:xx:xx:xx:xx:xx            4.1.0.8     Enabled   3          1          backup
3     xx:xx:xx:xx:xx:xx            4.1.0.8     Disabled  4          2          slave
4     xx:xx:xx:xx:xx:xx            4.1.0.8     Disabled  5          3          slave
5     xx:xx:xx:xx:xx:xx            4.1.0.8     Disabled  1          4          slave

Is this Ok?

Please note that, I have removed Mac Ids.

Regards

Neelesh

It is seeing all of the switches, so it looks like it is working fine, it could be an issue with the LEDs, you could trying running the system light command and see if they light up then.

LEDs are working fine. When I start the switch they starts blinking but after some time they stops.

Regards

Hi,

I do not feel any performance issues with stack. Stack is working fine.

however how should I check for any errors regarding stacks? if there are any logs..

Also on all other switches Both the LEDs on both Stacking ports are showing some activities except these 2. So I thought to get expert advice from this forum.

Regards and thanks

Neelesh