Using Radius to set role based privilege-level users on S4148T-ON 10.5.2.

Question

Hello, We are trying to use Radius (Using FreeRadius specifically) for centralized user access management into our Dell S4148T-ON switches (Running 10.5.2.8 version), but have issues trying to find documentation on how to properly setup RBAC with the use of Vendor Specific Attributes with Radius. The configuration that I have is fairly straight forward and works for basic auth: aaa authentication login default group radius local radius-server host **** key **** Since I can't find any official documentation on what VSAs can be used in OS10, on older forum posts and older OS documentation I've found 3 options that seemingly worked on some hardware/software some time ago: Cisco-avpair = 'shell:priv-lvl=15' Force10-avpair = 'shell:priv-lvl=15' DellEMC-avpair = 'shell:priv-lvl=15' When sending any of these in the Access-Accept response from the Radius server to switch, the user still only gets the lowest privilege level assigned. According to this post Using-RADIUS-VSAs-for-RBAC - the solution is to enable authorization for radius, but on OS10 I don't seem to have this option for Radius, only for TACACS+: Switch1(config)# aaa authorization exec-commands role sysadmin default group ?tacacs+ To configure for tacacs server That seemed like a possibility in OS9 according to documentation - configure-aaa-authorization-for-roles  So my questions would be:  What are the supported VSAs that need to be sent in Radius responses to a switch running OS10? How can AAA authorization be enabled with Radius in OS10?

DELL-Marco B · Answer

Hello,

you can follow here for the AAA authorization

https://dell.to/3p9yOBn

also here some documentation about RADIUS on OS10

https://dell.to/3JPNNZa

also for AAA authentication and VSA, here

https://dell.to/3JPBR9A

I hope this doc helps.

Thanks
Marco

Andrius4 · Answer

Hello,

Your provided link for AAA authorization is for OS version 9.14.2.5 and is not applicable for OS version 10.5.2.8 as there is no option for commands:

aaa authorization role-only

line vty 1
login authentication test
authorization exec test

Could you please send exact commands on how to configure RADIUS authorization on OS10?

The link https://dell.to/3JPBR9A only shows how to use Cisco ISE to send a VSA, but does not exactly say what string needs to be sent in the Radius response from the Radius server too.

Thank you,

Andrius

DELL-Marco B · Answer

Hello, here the guide, page 1316 https://dell.to/3sgUwFB   Thanks Marco

Networking General

Was this post helpful?