When setting up new user I am getting an error

Question

Hello all, So I am following a basic setup that I have found online. I am getting stuck on setting up a user account. It is a dell powerconnect 5524. I am typing in the commands as follows Console(config)# username falkon password MustangGT03 level 15 Note: this is not the real password I am using. But even if I type a password of '12345' or 'password' I still get the same error.  Error: Wrong number of parameters or invalid range, size or characters entered. As far as I can tell I am typing everything as the tutorial says correctly. I am configuring this switch from scratch .  Any help would be greatly appreciated as I am on a time crunch and need to configure this quickly.

Abraham1493 · Answer

Thank you this has worked for me!

JoseGCH · Answer

SW-N3248TE-ON-SRV(config)# username Admin password ********* privilege 15% Error: Illegal parameter.

Networking General

Was this post helpful?