We have plug server on this stack step by step (in a period of 1or 2 months). So we don't see immediatly this issue.
For information, i have an another issue with the stack, the traffic is slow except for the server connect on the unit1. I think this is due to the hdmi cable (poor quality and i wonder if it is not hdmi 1.4). I'm waiting for hdmi 1.3a certified cable.
I don't know if the two issue is related ? Maybe a bad hdmi stack cable can corrupt the adress table ....
What is the sysuptime? I think the command "show system" will display this. Is sysuptime what you expect given that the stack has been running for over a month?
taljallad
2 Posts
0
October 13th, 2011 07:00
We have the same issue. bounce.
tomarch
3 Posts
0
October 13th, 2011 08:00
Dell support have proceed the remplacement of the master-unit.
Since the issue hasn't come back.
But i don't know if it is due to the exchange or the reboot and rebuild of the entire stack ....
Have you try to switch the master unit from unit1 to unit2 ? Or to reboot the stack ?
tomarch
3 Posts
0
October 13th, 2011 08:00
We have plug server on this stack step by step (in a period of 1or 2 months). So we don't see immediatly this issue.
For information, i have an another issue with the stack, the traffic is slow except for the server connect on the unit1. I think this is due to the hdmi cable (poor quality and i wonder if it is not hdmi 1.4). I'm waiting for hdmi 1.3a certified cable.
I don't know if the two issue is related ? Maybe a bad hdmi stack cable can corrupt the adress table ....
taljallad
2 Posts
0
October 13th, 2011 08:00
stack has been running fine for over a month, when they were initially set up.
bh1633
909 Posts
0
October 13th, 2011 08:00
Did this happen immediately or has the switch been performing well for some time and then this issue occured?
bh1633
909 Posts
0
October 13th, 2011 08:00
Please provide output of "show system".
Only Dell HDMI cables are tested, so other cables from electronics stores may not work well.
bh1633
909 Posts
0
October 13th, 2011 08:00
What is the sysuptime? I think the command "show system" will display this. Is sysuptime what you expect given that the stack has been running for over a month?