how to set jumbo frame on some specific interface

Question

Hi  I m using powerconnect N4000. As i have an iscsi vlan with equalogic but not directly connected on this N4000 switch i would like to specify jumbo frame only for specific interface. but when i enter in config mode for an interface i don't have acces ar any command concerning mtu then how can i activate jumbo frame only on specific interface?

EricDoutreleau · Answer

Hi Daniel

Isn't it dangerous to activate jumbo frame globbally as i have some network on this switch that doesn't support jumbo frame.

How can the switch knows that it should frgment some jumbo frame for this specifici vlan?

EricDoutreleau · Answer

We have problems with our equalogic and the guys on the support insist that we switch to jumbo frame.

Networking General

Was this post helpful?