powerconnect 3424 configuration

Question

When I setup my switch, it will keep the configuration until I loose power.  I have looked for a button on the GUI and a command for CLI to save config and it doesn't seem to have one.  am I missing the boat here or do I have some sort of hardware/flash issue.

viralbyte · Answer

In the File Management Section of the web interface, you can copy files. You need to copy the running-config to the startup-config. Should be the default selected in there. Oh, and the cli command is

3424#copy run start

Regards,
Viralbyte

Message Edited by viralbyte on 07-23-2007 10:26 PM

westeq · Answer

Thanks, I'll try that in the morning.  :smileyhappy:

Networking General

powerconnect 3424 configuration

Was this post helpful?