The problem is that the command is incomplete (this is a flaw in the documentation, there *should* be a corrected version available on our website):
The problem is that to access the web console, you must have admin (level 15) privileges. To configure this, you would need to run the following command when you create the username/password for the switch:
console(config)# username password level 15
Newly created user accounts are given guest access (level 0) by default unless you specify otherwise - this likely is the cause of the problem.
Another common mistake we've seen, is that you need to be sure your IP address/subnet mask were assigned to a VLAN, not an individual port. Assigning the IP to the port on a 3324/3348 effectively will remove it from any existing VLANs, turning it solely into a management port.
Andrew_Hicks1
2 Intern
•
169 Posts
0
February 27th, 2004 13:00
The problem is that the command is incomplete (this is a flaw in the documentation, there *should* be a corrected version available on our website):
The problem is that to access the web console, you must have admin (level 15) privileges. To configure this, you would need to run the following command when you create the username/password for the switch:
console(config)# username password level 15
Newly created user accounts are given guest access (level 0) by default unless you specify otherwise - this likely is the cause of the problem.
Another common mistake we've seen, is that you need to be sure your IP address/subnet mask were assigned to a VLAN, not an individual port. Assigning the IP to the port on a 3324/3348 effectively will remove it from any existing VLANs, turning it solely into a management port.