This post is more than 5 years old
6 Posts
0
375192
February 29th, 2012 11:00
Inherited a PowerConnect 3548
Hi all,
I have just taken charge of a network with a PowerConnect 3548 at its core. The previous admin just treated it as plug and play and as a result never configured it. Is there any easy way to configure it with an IP and enable SSH access and the web interface (I do have console access) or will I have to factory reset the device and step through the initial configuration interface, before I can get remote access?
Protis
6 Posts
0
February 18th, 2013 08:00
- YOU WILL NEED A SERIAL CABLE -
Login to the console via the serial cable,
en
delete startup-config
Sure you want to delete, y
reload
Save setting, n
sure you want to reload, y
When it reboots you will get the wizard.
rberg77
6 Posts
0
February 29th, 2012 11:00
Thank you, from a previous look see via console session the Setup Wizard was not coming up, I was just dropped to a console prompt so manual configuration will do.
Out of curiosity, is there a way to re-run the setup wizard from CLI?