I am onsite today at another customer. Will need to install switches tomorrow and will just patch them in, if I can not solve it by tomorrow. I will check the logs and see if I find something. How do I refresh the firmware? Is that the .rfb boot file? I tried updating that file similar to the software image file, but it failed. Couldn't do it before on other good stack switches, so maybe I don't know how to do it. Is there an article reference for this that you can provide? Also, I do have two HDMI cables, but same result with each. Thank you for the reply.
Are my software and boot versions up-to-date (see first blog entry)? And if the boot version needs to be updated or if you think I need to re-flash it, then let me know, please. Also, I am assuming that the boot file is the .rfb file. Is that correct? The PDF xmodem section only talks about the .ros file. Can you update the boot that way? The software version was just updated on both units and I don't think that is my problem. Maybe one of the HDMI ports are bad on one of the units. Just at a loss, but will check the logs tomorrow.
Mike LP
3 Posts
0
July 24th, 2014 10:00
I am onsite today at another customer. Will need to install switches tomorrow and will just patch them in, if I can not solve it by tomorrow. I will check the logs and see if I find something. How do I refresh the firmware? Is that the .rfb boot file? I tried updating that file similar to the software image file, but it failed. Couldn't do it before on other good stack switches, so maybe I don't know how to do it. Is there an article reference for this that you can provide? Also, I do have two HDMI cables, but same result with each. Thank you for the reply.
Mike LP
3 Posts
0
July 24th, 2014 15:00
Are my software and boot versions up-to-date (see first blog entry)? And if the boot version needs to be updated or if you think I need to re-flash it, then let me know, please. Also, I am assuming that the boot file is the .rfb file. Is that correct? The PDF xmodem section only talks about the .ros file. Can you update the boot that way? The software version was just updated on both units and I don't think that is my problem. Maybe one of the HDMI ports are bad on one of the units. Just at a loss, but will check the logs tomorrow.