PCIE Training Error

Question

Hello- i have an R620 that isn't completing POST.  It is getting stuck at PCIe Training Error: Embedded iDRAC Device 5.  Power cycling the server doesn't help.  i just tried to update the BIOS but the job says 'Lifecycle controller in use.  This job will start when lifecycle controller is available.'  Any help is appreciated.  Thanks!

Daniel My · Answer

Hello

The system is not completing POST. The iDRAC and LCC are built into the system board. If you are unable to resolve the issue by following the troubleshooting article then you will likely need to replace the system board.

www.dell.com/support/article/sln111201/

Thanks

noct · Answer

deleted

North America English PowerEdge Out of Warranty Support

Was this post helpful?