Skip to main content
Start a Conversation

Unsolved

This post is more than 5 years old

tech2006

1 Message

44445

December 10th, 2006 21:00

PowerEdge 1950 - Remove RAID

Hi,
 
I have just purchased 4 new PowerEdge 1950 servers with 2 x 500GB SATA Hdd's. I want to remove the Raid array so I can use the hdd's seperately. In the Raid Bios configuration I can only select Raid 0 or Raid 1, nothing about disabling the RAID. I can disable to the RAID in the system BIOS, but then no hdd's are detected.
 
Could anyone help me with trying to get these drives seperated and on their own?
 
Cheers,

Mark_A_Smith

2 Intern

 • 

827 Posts

December 11th, 2006 12:00

The Perc5i controller only does Raid.  It does not have a non-Raid mode.  You can simply setup each drive as a Raid 0 and this will do the same thing as two stand-alone drives.

Was this post helpful?

View All

0 events found

No Events found!

Top