Dell Poweredge r610 Perc6i battery failed, replacement also showing as failed
Got an alert that the battery for the Perc6i was in a failed state. Replaced with a new battery and now in the logs it's showing battery is good, battery is failed, over and over. In the alert logs it shows that the batter is unable to maintain a charge.Does it need to run a learn cycle or is there any other steps other than replacing the battery?
Is it possible a new battery is bad? Does it need more than 12 hours to recharge? Is there something on the controller that has failed?
Its possible that you received a failed battery, or that the connector on the PERC itself has an issue. It's been my experience with this sort of error that if replacing the battery didn't resolve the issue, it's likely that connector on the PERC. That having been said, I'd recommend double checking that the firmware on the PERC is up to date. It may resolve the issue, though I would suspect that you'll ultimately need to replace the controller.
Working with the vendor on the battery issue just to see what they say. The cable that comes with the replacement batter is only like 4" long so I have to use the cable that's already in the server. Controller seems to be healthy otherwise but I guess it could be having an issue, there's no symptoms or events related to the controller specifically, just the battery. The log entries that show the batter being good and then bad over and over are really weird. Not sure what that's about. There's one revision for the FW of the controller which I can certainly try.