Unsolved
This post is more than 5 years old
7 Posts
0
117140
How can I exit the IPMI firmware update mode
In IPMI I had enter the Update function by mistake, that I click Cancel without operation
But It seem abnormality, I visited the IPMI Page then it show error message as below
Access Error: Target device firmware is being upgraded and not currently available.Please try again after update completes.
Card in flash mode !
Can I exit the firmware update mode?
Hardware:DCS 6005(Poweredge C6105?)With Opteron Processors 2419 EE
DELL-Chris H
Moderator
Moderator
•
8.8K Posts
0
May 19th, 2014 08:00
Loveminds,
I would power down the server and reset the NVram jumper on the system board and see if that clears the issue. You can also try initiating a new update via the TFTP Flash interface using IPMItool. You can get details on this on page 15 of this guide- http://bit.ly/1hXEfY5
This is the current version of the BMC - http://downloads.dell.com/FOLDER01674113M/1/PEC6100BMC133.exe
Let me know what you find.
loveminds
7 Posts
0
May 19th, 2014 09:00
But this Server is C6105, it's compatible with C6100's BMC?
DELL-Chris H
Moderator
Moderator
•
8.8K Posts
0
May 19th, 2014 10:00
Here is the proper download, sorry about that - http://www.dell.com/support/home/us/en/555/Drivers/DriversDetails?driverId=H0J2J&fileId=3325837829&osCode=NAA&productCode=poweredge-c6105&languageCode=EN&categoryId=ES
loveminds
7 Posts
0
May 21st, 2014 06:00
I Try to Cut power then restart, impi can work but i still can't using Java Console
This is the system information
Device Power Status : On
Firmware Revision : 1.03
AuxFirmware Revision : 1
Firmware Build Time : Feb 24 2010 11:37:14
loveminds
7 Posts
0
May 21st, 2014 06:00
Which BMC I Can Update via Webpage
loveminds
7 Posts
0
May 21st, 2014 08:00
What should i do to flash on the web control,which file should be downloaded then upload to the webcontrol page.
DELL-Chris H
Moderator
Moderator
•
8.8K Posts
0
May 22nd, 2014 05:00
On the second link I sent you will use the one that corresponds to the OS you have installed. What is the OS that is installed?
Also, when you did the restart, did you also do the jumper procedure for clearing the NVRam, or did you just restart it?
beyeriii
1 Rookie
1 Rookie
•
29 Posts
0
March 2nd, 2015 15:00
Try using ipmitool to do a BMC cold reset,
On a Linux box
$sudo apt-get install ipmitool
$ipmitool -I lanplus -H 77.77.77.77 -U username -a bmc reset cold
There are similar tools available on Windows.