Unsolved
This post is more than 5 years old
3 Posts
0
123740
PE2950 Server - E1410 SYSTEM FATAL ERROR
Hi People
I really hope somebody can advised on what this error actually translates to?
The server when powered up does not even start its POST and just displays the above error on the LED screen of server.
I have Googled this error and have found many similar issues but not this specific one, but for the record I have followed the below steps already just to see if it helped:
Re-seated all Memory dims
Removed and re-seated both CPUs and both heat sinks
Nothing changed the status message or started POST.
Does anyone have any suggestions or anyone seen this before and fixed it?
Any advise welcomed.
Many thanks
Nitrox1234
Dylank
1 Rookie
1 Rookie
•
104 Posts
0
September 14th, 2015 08:00
I would try one cpu at a time, along with that I would try going down to 1 or 2 sticks of ram and rotating them out to rule out bad ram, also try pulling any expansion cards including the raid controller.
If none of that gets it posting I would look at the mainboard being the culprit,
Nitrox1234
3 Posts
0
September 14th, 2015 09:00
Hi
Thank you have tried this now and also no joy, will assume system board issue then?
Thanks
Nitrox1234
Dylank
1 Rookie
1 Rookie
•
104 Posts
0
September 14th, 2015 14:00
Yeah, if nothing else got it I would definitely look at the board at this point.
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
September 14th, 2015 15:00
Hello.
The message code "e1410" indicates that the processor has had an internal error (IERR), but this doesn’t always mean that CPU is the problem.There are a large variety of issues that cause an IERR besides the CPU.
Bring the system to minimum to POST with the following components:
Ensure that all USB devices including keyboard and mouse are disconnected.
Let me know whether this isolates the problem, otherwise proceed with motherboard replacement.
gtDELL1
1 Message
0
October 22nd, 2015 13:00
Did you replace the board?
ashahini
8 Posts
0
December 17th, 2015 08:00
Hello,
I have replaced the motherboard in dell power edge 2950 . I have same problem,
Please can help somebody, what can I do to solve?
Best regards,
Andrin
MunsifHasan
1 Message
0
December 6th, 2021 08:00
2 Bronze
I have faced the same error in R610 and the same has been fixed after CPU replacement.