1 Rookie
•
8 Posts
0
2004
January 13th, 2023 09:00
SNMP OID for inlet/exhaust temperature on R650 iDRAC9
I am using .1.3.6.1.4.1.674.10892.5.4.700.20.1.6.1.1 for inlet temperature and .1.3.6.1.4.1.674.10892.5.4.700.20.1.6.1.2 for the exhaust temperature read-out for our R440 servers.
The values I get from these sources on the new R650 machines are at least a factor 2 off, so I guess these are not the OIDs for the inlet and exhaust sensors.
Where do I find the correct SNMP OIDs?
I found https://www.dell.com/community/PowerEdge-Hardware-General/snmp-OID-for-inlet-temp-on-R620-iDRAC7/td-p/4483082 which is a similar question but for R620 and the link there leads to the Dell community, not to the mentioned manual. I also looked through the R650 Installation and Service Manual but no luck.
No Events found!
DELL-Chris H
7 Practitioner
•
9.7K Posts
•
48K Points
0
January 13th, 2023 13:00
Tamasgal,
The OIDs you are looking for can be found in the MIB download found here.
Let me know if this helps.
tamasgal
1 Rookie
•
8 Posts
0
January 14th, 2023 07:00
I am not sure if I understand. That link leads to to prtHdslMaxRate(4), no idea how to relate that to the inlet/exhaust sensors I also don't see how to search for that sensor in that repository.
tamasgal
1 Rookie
•
8 Posts
0
January 15th, 2023 03:00
It seem the link has been updated, now it points to the mib-files. Thanks!
For the sake of completeness, here are the OIDs I was looking for:
1.3.6.1.4.1.674.10892.5.4.700.20.1.6.1.2 "System Board Inlet Temp"
1.3.6.1.4.1.674.10892.5.4.700.20.1.6.1.3 "System Board Exhaust Temp"
Nortag
1 Message
0
June 12th, 2023 12:00
Hi tasmasgal,
I added this OID on a T440, using PRTG, not a biggy, but getting a value of 250, temp is 25C. Others getting the same values? like 3 digits?