Unsolved
This post is more than 5 years old
3 Posts
0
20388
blink/unblink physical disk
Hello all,
I'm new to racadm raid commands but I was able to find some useful commands. I got a question regarding blink/unblink. How do I get the status of the blink flag after using "racadm raid blink:Disk.Bay.4:Enclosure.Internal.0-0:RAID.ChassisIntegrated.1-1" or "racadm raid unblink:Disk.Bay.4:Enclosure.Internal.0-0:RAID.ChassisIntegrated.1-1"
DELL-Daniel My
Moderator
Moderator
•
6.2K Posts
0
February 21st, 2018 13:00
Hello
Please send a private message with your service tag to ensure we have all appropriate information on your system.
Thanks
SluggoMagoo
3 Posts
0
February 22nd, 2018 02:00
I don't seems to have access to private messages. I'm working on a PowerEdge VRTX.
DELL-Daniel My
Moderator
Moderator
•
6.2K Posts
0
February 22nd, 2018 11:00
I don't show that you are a member of the registered users group. There may be something in your account setup that is not completed.
I have been unable to find anywhere that the blink status is monitored. I doubt this is something that is reported. I have been unable to find any management or monitoring program that reports the current blink status. The only capability I have found is to send either a blink or unblink command. Based on my research, it does not appear possible to get the blink status..
Thanks
SluggoMagoo
3 Posts
0
February 22nd, 2018 11:00
So if you're not in front of the array, you can't tell if the lights blinking? :smileysad: