Our company has a Dell Power Edge R300 Server (Rack Type) with Server 2003 x64 Standard Edition which is used for Exchange Server 2007 Standard Edition.
Now we are planning to re-build the exchange server, but we have exchange information store error..
Then we planned to re-install the server 2003 through bootable Server 2003 x64 DVD which boots successfully and further it gives us the below error,
Setup did not find any hard disk installed in your computer. Make sure any hard disk drives are powered on and properly connected. And any disk related configuration is correct.ect.
Press F3 to quit.
Then i tried to boot from the Dell Systems Build and Update Utility, it doesnt boot and further server 2003 starts. ( I checked the Dell DVD by booting it in another machine it boots)
Do i need to uninstall the Dell System Administration or Installation files from the system and then try booting?
The message means that Windows didn't find your PERC controller. This is because it doesn't have a driver for it (native on the Windows install CD/DVD). To get Windows to install you have to download the PERC driver and extract it to a floppy drive. Now you reboot to the Windows CD and at the early stages (where it is scanning for raid and scsi adapters) you press F6 to manually add a scsi/raid driver. You have it load the driver from the floppy and it now should see the raid disk and be able to install Windows.
Member since 2003
Thanks Dev Mgr for your kind reply.
would like to know if i could get the driver PERC 6/E installed to a external hard drive rather a floppy disk?
Tosh, you might have a couple of choices here. When trying to boot to SBUU disc, press F11 when prompted in the upper right corner at post, press F11 and then select to boot from theoptical drive.
The other option is does your R300 have an idrac in it? if so, when booting press F10 to enter the Unified Server Configurator, and then choose OS deployment when you get in, then select the OS you are trying to install, and follow the steps.
I tried a couple of times to boot from SBUU disc but couldnt get on, windows server starts from there on......
www.dell.com/.../R300_Spec_Sheet_new.pdf, i dont find idrac in it....
Rey's options will be the easiest on you, but if they don't work, then you can as Dev Mgr says, and load the driver. 2003 can ONLY get a driver during the installation process from a driver (modern OS's can use USB, CD, etc.). If you don't have a floppy disk, you can use nLiteOS.com to integrate your RAID driver into your installation media ... this will create a new CD from which you can install with the drivers already on it.
What RAID controller do you have? Some controllers (PERC 6/H700) require you to configure RAID BEFORE Windows will see any drives, even with the right driver.
Floppy to install RAID drivers after pressing F6 during install or you can slipstream/inject the drivers into your install media like explained in this article.
Controller is SAS 6/iR Adapter
I Still when on to boot from the SBUU disc it doesnt...
Any solution further....
Download nLite (http://nliteos.com) and the SAS 6/iR 2003x64 driver:
Use nLite to integrate the driver into the installation media (this will create a new CD). You will also need to have Service Pack 2 on your 2003 media (you can use nLite to integrate that too if you don't already have it).