Unsolved
This post is more than 5 years old
2 Posts
0
5304
May 20th, 2004 15:00
RAID system alert management
Hi ,
I have installed Linux 8.0 on a PowerEdge 1600SC with RAID controller. I use raid 10 configuration ( 4 hard disk )
How could i monitor a failure in one of the hard disk and receive an alert email ?
Thanks
No Events found!
Eric BY
2 Intern
•
815 Posts
0
May 28th, 2004 20:00
Try this:
ftp://ftp.dell.com/scsi-raid/aacraid-util-rh8.0-i386.tar.gz
ftp://ftp.dell.com/scsi-raid/afa-apps-snmp.2806076-A02.tar.gz
lioardi
2 Posts
0
June 1st, 2004 06:00
I omited the following informaton : i have a megaraid controller so i have installed a megaraid-util-rh8.0
I received the following message :
PERCRAID Monitor Service Ver 3.8 (40-LD) Jan 08, 2003 started
MailFlag value set as:-
MailFlag: 1 (0-means no mailing of events will be done
1-means events will be mailed also).
-: Initial CheckConsistency Schedule :-
EnableFlag: 1
Date: 05/21/2004
DayOfWeek: 0
HourOfDay: 0
Week(s): 1
ReportChkonProgInterval: 0 seconds(0 means report in-frequently)
-: Initial SMART Polling Schedule :-
SMARTPollingOn: No
SMARTPollingInterval: 20 Seconds
The question is :
It is all ok to receive an alert mail and how ca I modified the schedule parameters ?
Best