I would check the system to see what hardware devices are attached. I show that 2008R2 is a supported OS on the 2850, but there may be installed hardware that is not supported. If a driver is not listed on the support page of the server for a supported operating system then it uses the native driver in the OS.
Long story short, I am trying to get some life our of an older PE2850 and I have 2008 r2 installed however I have two issues. First, there are 3 PCI devices that are missing drivers in Device Manager. I've tried a zillion things, but no luck, one says 'Infiniband Controller', another just 'PCI Device', a third says 'PCI Serial Port'. Funny thing is the server has just the on-board PERC4 and a PERC5 in the slot (connected to an MD1000) and both of those show up just fine (though the second issue is that the PERC4 does not show up in OpenMange... grrrr..., but the PERC 5 does). The serial port also shows up fine as COM1.
Again, tried a zillion things but I noticed that all the device property hardware IDs start with PCI\VEN_15BC&DEV_2530... etc . From what I can tell and from what I see in OpenManage, that vendor is 'Agilent Technologies'. So.. I have found no help searching for drivers for anything like that. Any thoughts are greatly appreciated. Thanks.
Daniel My
10 Elder
•
6.2K Posts
0
January 23rd, 2018 14:00
Hello
I would check the system to see what hardware devices are attached. I show that 2008R2 is a supported OS on the 2850, but there may be installed hardware that is not supported. If a driver is not listed on the support page of the server for a supported operating system then it uses the native driver in the OS.
https://www.dell.com/support/
Thanks
papaJon0s1_M
1 Rookie
•
11 Posts
0
January 31st, 2018 13:00
Hello,
Long story short, I am trying to get some life our of an older PE2850 and I have 2008 r2 installed however I have two issues. First, there are 3 PCI devices that are missing drivers in Device Manager. I've tried a zillion things, but no luck, one says 'Infiniband Controller', another just 'PCI Device', a third says 'PCI Serial Port'. Funny thing is the server has just the on-board PERC4 and a PERC5 in the slot (connected to an MD1000) and both of those show up just fine (though the second issue is that the PERC4 does not show up in OpenMange... grrrr..., but the PERC 5 does). The serial port also shows up fine as COM1.
Again, tried a zillion things but I noticed that all the device property hardware IDs start with PCI\VEN_15BC&DEV_2530... etc . From what I can tell and from what I see in OpenManage, that vendor is 'Agilent Technologies'. So.. I have found no help searching for drivers for anything like that. Any thoughts are greatly appreciated. Thanks.