Hi,

Here is the user guide for rail installation and removal for the server: https://dell.to/2P0YJIQ

There is information on how to mount and pull the rails into the rack, but no information on how to remove the server from it

Hello Szazi,

The directions for removing the server are on page 2 of the PDF Joey provided:

Installing and removing the system

2. Follow the procedures in this section to remove the system from

the rack.

i. Rotate the slam latches upward, on each side of the

system, to release the system.

ii. Hold the sides of the system and pull it forward until the

inner slide rails are fully extended.

iii. Rotate and hold the server-lock latch while pulling the

system firmly to slide the standoffs to the front of the

J-slots.

iv. Lift the system out of the rack.

NOTE: To secure the system for shipment in the rack or for other

unstable environments, locate the screw under each slam latch

and tighten each screw by using Phillips #2 screwdriver.