Virtualization Questions

Question

Hello, I need some advice on server virtualization. My clients generally all want 'dedicated' servers, the traditional way but my cabs are getting stacked and a bit costly, cumbersome. I’m looking to virtualize my servers. Below is a sample quote from my server vendor. The below is $22k plus another $6k for 16 x 2TB SSD drives from Amazon. I use SolusVM control panel for my VPS customers which is simplified. Only downside is it cannot virtualize a bunch of physical servers as far as I know, plus I cannot add bulk IPv4 addresses in one shot when assigning them to individual VMs. Most clients lease large quantity of IPs from me.  For starters, I was looking to start off with the below sample config:  Four Intel Xeon E5-4657L v2 Twelve Core 2.4GHz 30MB 8GT/s 115W1024GB (8 x 32GB) x (4 CPU) PC3L-10600LPERC H710p 1GB NVWC 6G (RAID 0, 1, 5, 6, 10, 50, 60)Small Form Factor - (SFF - 2.5in) Supports 8 DrivesSecond 8-Bay Drive Cage with 16 x 2.5in Bay Backplane 16 x 2TB SSD (Micron)Dell Broadcom 57800 - Dual 10Gb RJ-45, Dual 1Gb RJ-45 (NDC)iDRAC 7 Enterprise with 8GB vFLASH CardDual 1100W Redundant Power Supply  Do you think VMware’s vSphere Hypervisor free product is sufficient? I also considered CloudStack. Any better virtualization software you might recommend? If I client wants a full GigE uplink, how would that work say on above config with dual 10G and I have more than 20 clients on the same box? Since the above config is 48 cores total, suppose I sell 50 'virtual dedicated servers' with 24 cores each, is there a physical limit within VMware or is it somewhat like shared hosting where you can oversell bandwidth, disk space per se? Since I’d install 16 x 2TB SSDs (I would use RAID-0 for optimal performance and full storage amount), would these be easily hot-swappable should one drive fail? Would I be able to sell more than the physical amount allocated? In other words, if I have 10 VMs with 2TB each, that’s physically 20TB total but each VM is generally using far less. Does VMware put an actual allocation limit based on physical limitations of the hardware itself?

DELL-Josh Cr · Answer

Hi,

Here are some tools that can assist with planning for capacity. http://www.dell.com/learn/us/en/04/smb/virtualization-planning-and-assessment---the-pain-is-worth-the-gain

You may also be better with less hardware in the server and multiple servers.

RAID-0 is not recommended for a production environment because there is no redundancy and if any drive fails you lose all of the data on all of the drives.

Rack Servers

Was this post helpful?