This post is more than 5 years old
10 Posts
0
3166
May 28th, 2015 13:00
Exception. Failed creating virtual repository
I'm getting the following error during the setup process of Recover Point for VM's. Please advise.
"Exception. Failed creating virtual repository"
No Events found!
wyp1
5 Posts
0
July 9th, 2015 18:00
yes. the folder is created.
forshr
2 Intern
•
1.1K Posts
0
July 10th, 2015 01:00
Remove it completely, reboot the vRPAs and reattempt the deployment from the beginning.
Rich Forshaw
Consultant Corporate Systems Engineer - RecoverPoint & VPLEX (EMEA)
Data Protection and Availability Solutions
EMC Europe Limited
Mobile: +44 (0) 7730 781169
E-mail: richard.forshaw@emc.com
Twitter: @rw4shaw
Impending vacation: 15th – 28th of July
EMC Europe Limited
Registered in England with Company No. 00990752 Registered office address: Level 1, Exchange House, Primrose Street, London C2A 2EG
The information contained in this e-mail message and any files transmitted with it are confidential. It is intended only for the addressee and others authorised to receive it. If you are not the intended recipient or the person responsible for delivering the message to the intended recipient, you are advised that you have received the e-mail in error; please delete it and notify the sender immediately. You should not retain the message or disclose its contents to anyone. Any disclosure, copying, distribution or action taken in reliance on the contents of the e-mail and its attachments is strictly prohibited.
wyp1
5 Posts
0
July 12th, 2015 20:00
still the same error message.
I did try remove everything and start from scratch also received the same error message.
forshr
2 Intern
•
1.1K Posts
0
July 13th, 2015 01:00
Can you attach the dm and ui log files.
wyp1
5 Posts
0
July 13th, 2015 23:00
Logs attached
2 Attachments
dm.log
ui.log
Idan
3 Apprentice
•
675 Posts
0
July 14th, 2015 23:00
Hi,
It's possible that the dummy VMDK was created, added to the VMDKs (10MB one) but failed to be attached.
You can try to remove it from the vRPA/ redeploy the vRPA OVAs, remove the RPvStorage directory and try again.
Since this is a new install, I would recommend installing RP4VM 4.3 which contains many enhancements and fixes, including issues with CreateAndAttachRPDeviceAction which can be seen in your case.
Regards,
Idan Kentor
Corporate Systems Engineer - RecoverPoint and VPLEX
idan.kentor@emc.com
@IdanKentor