Unsolved
This post is more than 5 years old
2 Posts
0
1029
July 28th, 2014 12:00
How to update Unisphere to point to a new RPA cluster
Long story short, I had to rebuild my RPA cluster due to a bad install by a consultant. My Unisphere is still pointing to the old RPA cluster IP so it can't connect. I get this lovely error message.
When I click on "Configure RecoverPoint Settings" I get this lovely error message:
The RPAs are fully up and working. They are actually replication all of our data and works perfectly. I just need to integrate it back with Unisphere for one management console. I have an open SR but they are having a hard time with it. Any ideas on how to change that? Thanks!
Unisphere for RecoverPoint V4.1
Unisphere on my VNX5400 V1.3.2
0 events found
No Events found!
billsoft_ggardn
2 Posts
0
July 28th, 2014 13:00
No I am not. Thanks!
forshr
2 Intern
•
1.1K Posts
0
July 28th, 2014 13:00
Where you using LDAP?
StoreMan45
1 Message
0
July 28th, 2014 14:00
I had similar experience. grrr...
Marcelo Soria
1 Rookie
•
1 Message
0
September 16th, 2014 09:00
Hi, Bill. I got the same error, and in order to undestand the issue I put my notebook inside the Datacenter in the same network of the storage and rpa's for snif the network... and I realize that the problem was the proxy.. I added the whole IP's in my Internet Explorer proxy configurations and everything works.
I hope this could help. regards
Marcelol
AndrePar
9 Posts
0
April 23rd, 2015 06:00
Hello
I am having this same issue, did you manage to find a fix?
Would be grateful if you could share
Thanx
Andre